Hawk-industries Hawkjaw Jr. Manual 65K-ALS Serial Numbers 4 to 9 Manuel d'utilisateur télécharger pdf (Page 44)

Changing the Heel Dies (cont.)

3/4" wrench, See Drawings p. 128.

Tools Required

1. Make sure the HawkJaw is off the

drill pipe connection and in the rest

position on the derrick.

2. Shut down the Hydraulic power

unit.

3. Press, push, and pull all control

buttons repeatedly to bleed

hydraulic pressure.

4. Disconnect the Air power supply.

5. Press, push, and pull all control

buttons repeatedly to bleed air

pressure.

6. Assume that there is still a load on

every actuator. Proceed with

caution.

Initial Steps

Bottom Wrench Heel Die

1. Use the 3/4" wrench to remove the

Heel Die Bolts (B).

2. Pull out the Heel Die Pin (P).

3. Pull out the Die Holder (DH).

4. Slide out the worn Die (D).

5. Make sure the back and sides of

the new Die are clean.

Continued on next page.

44 Maintenance & Repair

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 138 139

Pas de commentaire

Hawk-industries Hawkjaw Jr. Manual 65K-ALS Serial Numbers 4 to 9 Manuel d'utilisateur Page 44