Hawk-industries Hawkjaw Jr. Manual 65K-ALS Serial Numbers 4 to 9 Manuel d'utilisateur télécharger pdf (Page 9)

Hanging Cable Location

1. Anchor the hanging cable to a point as close to the derrick crown as possible. The longer the

hanging cable, the easier the HawkJaw is to move on and off the drill pipe.

2. Locate the cable hang point as high above the center of the rotary table as possible. The

cable must hang within 2'-4' ft. of the rotary table center.

Installation

9Installation

HawkJaw Location

1. Place the HawkJaw on the side of the rotary table away from the setback zone. This

allows the drill pipe stands to swing straight from pick-up to stabbing.

2. If possible, place the HawkJaw on the opposite side of the setback zone. If the rig has dual

setback zones, Step 1 applies.

3. The HawkJaw may rest on the rig floor 3' -5' ft. away from the rotary table.

NOTE

The hanging cable must permit the HawkJaw to move from the drill pipe connection to the

mouse hole connection to the HawkJaw rest position (3'- 5' away from the rotary table).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 138 139

Pas de commentaire

Hawk-industries Hawkjaw Jr. Manual 65K-ALS Serial Numbers 4 to 9 Manuel d'utilisateur Page 9