Hawk-industries Hawkjaw Sr. Manual 100K-2GSR Serial Numbers 121 to Manuel d'utilisateur télécharger pdf (Page 10)

Installation 9

HawkJaw Location

Hanging Cable Location

1. Anchor the hanging cable to a point as close

to the derrick crown as possible. The longer

the hanging cable, the easier the HawkJaw is

to move on and off the drill pipe.

2. Locate the cable hang point as high above

the center of the rotary table as possible. The

cable must hang within 2'-3' ft. of the rotary

table center.

NOTE

The hanging cable must permit the HawkJaw to

move from the drill pipe connection to the mouse

hole connection to the HawkJaw rest position

(3'- 5' ft. away from the rotary table).

1. Place the HawkJaw on the side of the

rotary table away from the setback zone.

This allows the drill pipe stands to swing

straight from pick-up to stabbing.

2. If possible, place the HawkJaw on opposite

side of the setback zone. If the rig has dual

setback zones, Step 1applies.

3. The HawkJaw may rest on the rig floor 3' -

5' ft. away from the rotary table.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 191 192

Pas de commentaire

Hawk-industries Hawkjaw Sr. Manual 100K-2GSR Serial Numbers 121 to Manuel d'utilisateur Page 10