Hawk-industries Hawkjaw Sr. Manual 100K-2GSR Serial Numbers 101 to Manuel d'utilisateur télécharger pdf (Page 9)

Hanging Cable Location

1. Anchor the hanging cable to a point as

close to the derrick crown as possible.

The longer the hanging cable, the easier

the HawkJaw is to move on and off the

drill pipe.

2. Locate the cable hang point as high

above the center of the rotary table as

possible. The cable must hang within

2'-3' ft. of the rotary table center.

Installation

9Installation

NOTE

The hanging cable must permit the

HawkJaw to move from the drill pipe

connection to the mouse hole connection to

the HawkJaw rest position (3'- 5' ft. away

from the rotary table).

HawkJaw Location

1. Place the HawkJaw on the side of the

rotary table away from the setback

zone. This allows the drill pipe stands

to swing straight from pick-up to

stabbing.

2. If possible, place the HawkJaw on the

opposite side of the setback zone. If

the rig has dual setback zones, Step 1

applies.

3. The HawkJaw may rest on the rig floor

3' -5' ft. away from the rotary table.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 164 165

Pas de commentaire

Hawk-industries Hawkjaw Sr. Manual 100K-2GSR Serial Numbers 101 to Manuel d'utilisateur Page 9